How to Configure XP-SNET Controller for Global Antipassback (GAC) Application

Problem (Issue) Statement	How to configure XP-SNET Controller for Global Antipassback (GAC) Application
Description:	A guide to configure XP-SNET controller for Global Antipassback (GAC) application Note XP-SNET-GAC controller is only supported for LAN Network Communications only. . Tip Controller models supported as GAC Client: XP-SNETv3.36, XP-SNETv4, XP-M2000i v6.10 and above, and XP-M1000i v6.00 and above.
Related Software:	xPortalNet v1.5.0.90 above
Related Hardware:	XP-SNET_GAC v2.24 XP- SNETv2 v3.36 and above
System Application:	Global Antipassback feature
Symptom and Finding:	NIL
Cause:	A guide to configure XP-SNET controller for Global Antipassback (GAC) application.
Solution:	Warning! XP-SNET-GAC currently do not support odd numbered card lengths, e.g. 5, 7, 9 card number lengths. Summary: To perform ColdStart for first power up. To perform pre-configuration setting for the network connection. To configure IP Address for XP-SNET. To configure Master IP Address and Port point to XP-SNET-GAC. Step-by-step Guide: To perform ColdStart for first power up: Step 1: Press & hold COLDSTART button on XP-SNET board. Step 2: Press & release RESET button on XP-SNET board. Step 3: Wait for STAT & CPU LED to light up simultaneously. Step 4: Release COLDSTART button. Note User are advised to perform ColdStart operation once after every first time power up of the controller; or when advised to do so by the technical support. To perform pre-configuration setting for the network connection: Knowledge Base Link User may refer How to Pre-configure Network Connection for IP Controllers* to complete the process.* To configure IP Address for XP-SNET: Knowledge Base Link User may refer How to Configure IP Address for IP Controllers* to complete the process.* To configure XP-SNET-GAC IP Address as the Master IP Address: Knowledge Base Link This configuration process must be configured on XP-SNET controllers with firmware v3.71 or lower. Step 1: After completing the process to configure the IP address. Users should scroll down the Network Setting page. Step 2: Configure the Master Controller IP Address and Master Controller Port as XP-SNET-GAC's IP address and communication port respectively. Click Submit to save the changes made. Figure 1: Configuring Master Controller IP Address and Master Controller Port
Common Issue	NIL
Date Documentation:	3/10/2018 (Rev 1.0)

PROOF-READ

.

Technical Knowledge Base

How to Configure XP-SNET Controller for Global Antipassback (GAC) Application

Analytics

XP-SNET-GAC controller is only supported for LAN Network Communications only.

XP-SNET-GAC currently do not support odd numbered card lengths, e.g. 5, 7, 9 card number lengths.

Summary:

To perform ColdStart for first power up.

To perform pre-configuration setting for the network connection.

To configure IP Address for XP-SNET.

To configure Master IP Address and Port point to XP-SNET-GAC.

Step-by-step Guide:

To perform ColdStart for first power up:

To perform pre-configuration setting for the network connection:

To configure IP Address for XP-SNET:

To configure XP-SNET-GAC IP Address as the Master IP Address:

Related Articles.

Related content