How to Configure Jumper Settings for XP-SNET-E32R Output Relays

Problem (Issue) Statement:	How to configure jumper settings for XP-SNET-E32R output relays
Description:	A guide to configure jumper settings for XP-SNET-E32R output relays.
Related Software:	NA
Related Hardware:	XP-E32R
System Application:	Lift Masking Lift Access System Alarm Monitoring System
Symptom and Finding:	NA
Cause:	For first time configuration on jumper settings for XP-SNET-E32R output relays.
Solution:	Summary To configure jumper settings on XP-SNET-E32R output relays. Step-by-step Guide: To configure jumper settings on XP-SNET-E32R output relays: Step 1: The jumper settings location for the output relays are shown as below: Figure 1: Jumper settings location for the XP-SNET-E32R output relays Note Please note that for output relays 17 to 32, the jumpers are upside-down compared to the jumpers for output relays 1 to 16. Step 2: Follow the table below to configure the jumper settings according to the specification for the output relays (dry contact vs wet contact & NO contact vs NC contact). Note The black bar indicates the pins required to be shorted. The default jumper setting on XP-SNET-E32R extension board is Wet Contact* with NO type.*
Date Documentation:	23/5/2018 (Rev 1.0)

PROOF-READ

.

Technical Knowledge Base