How to Connect XP-SNET Controller to XP-SNET-E32R Extension Board for Lift Masking System Application
Problem (Issue) Statement: | How to connect XP-SNET controller to XP-SNET-E32R extension board for Lift Masking System application |
Description: | A guide to connect XP-SNET controller to XP-SNET-E32R extension board for Lift Masking System application. |
Related Software: | NA |
Related Hardware: |
|
System Application: |
|
Symptom and Finding: | NA |
Cause: | For first time connection between XP-SNET controller with XP-SNET-E32R extension board for Lift Masking System application. |
Solution: | Warning! The XP-SNET controller will not send fire alarm signal over to the connected XP-SNET-E32R and/or XP-SNET-E248 extension boards if the configuration settings for the XP-SNET controller is not completed.Complete the configuration settings for XP-SNET controller in order for XP-SNET-E32R and/or XP-SNET-E248 to respond accordingly to fire alarm signals.. . Summary
Step-by-step Guide:
Knowledge Base Link Ensure that XP-SNET controller is configured to Lift Controller Mode. Users may refer to How to Assign XP-SNET Controller to Function as Lift Controller for the complete steps. . .
Step 1: Please follow the wiring diagram as shown below:
. .
Knowledge Base Link Users can refer to How to Configure Address Unit No on XP-SNET-E32R Extension Board for the complete procedures on configuring the address settings on XP-SNET-E32R extension board. |
Date Documentation: | 19/6/2018 (Rev 1.1) |
PROOF-READ
.
.
.
© MicroEngine Technology Sdn Bhd (535550-U). All rights reserved.