How to Configure Address Unit no on XP-SNET-E248 Extension Board

Owned by Tan Rong Wei (Unlicensed)
Last updated: Dec 30, 2020
2 min read

Problem (Issue) Statement:

How to configure address unit no on XP-SNET-E248 extension board

Description:

A guide to configure address unit no on XP-SNET-E248 extension board.

Related Software:

NA

Related Hardware:

  • XP-SNET-E248

System Application:

  • Lift Masking Lift Access System
  • Alarm Monitoring System

Symptom and Finding:

NA

Cause:

For first time configuration for address unit no on XP-SNET-E248 extension board.

Solution:







Summary

  • To configure DIP switches for address setting on XP-SNET-E248 extension board:

  • To observe the XP-SNET and XP-SNET-E248 response after configuring the address of XP-SNET-E248.

Step-by-step Guide:

  • To configure DIP switches for address setting on XP-SNET-E248 extension board:

Step 1: The XP-SNET-E248 address setting for the DIP switch can be referred to as shown below:
The DIP Switches for Address Setting Location on the XP-SNET-E248 Extension Board
Figure 1: The DIP switches for address setting location on the XP-SNET-E248 extension board


Step 2: The table below shows the different DIP switch configurations for the respective address settings:



Step 3: The table below shows an example of the DIP switches settings for a XP-SNET-E248 extension board to be configured with address setting of unit no. "01":


Note

The address of the extension boards must be unique (ranging from '00' to '03'), i.e.: no two extension boards in the same connection network can have the same address.




  • To observe the XP-SNET and XP-SNET-E248 response after configuring the address of XP-SNET-E248:

Step 1: On the XP-SNET controller, ensure that both D33 & D34 LEDs in the "Downlink" section (lower left section of XP-SNET controller) is blinking to indicate that the XP-SNET controller has successfully established communication with the XP-SNET-E248 extension board.

Step 2: On the XP-SNET-E248 extension board, ensure that both Uplink LEDs are blinking.

Date Documentation:

23/5/2018 (Rev 1.0)

PROOF-READ

.

Related Articles.

Containing the label "e248"

.

.

© MicroEngine Technology Sdn Bhd (535550-U). All rights reserved.