How to Configure Jumper Settings for XP-SNET-E32R Output Relays

Owned by Tan Rong Wei (Unlicensed)
Last updated: Dec 30, 2020
1 min read

Problem (Issue) Statement:

How to configure jumper settings for XP-SNET-E32R output relays

Description:

A guide to configure jumper settings for XP-SNET-E32R output relays.

Related Software:

NA

Related Hardware:

  • XP-E32R

System Application:

  • Lift Masking Lift Access System
  • Alarm Monitoring System

Symptom and Finding:

NA

Cause:

For first time configuration on jumper settings for XP-SNET-E32R output relays.

Solution:







Summary

  • To configure jumper settings on XP-SNET-E32R output relays.

Step-by-step Guide:

  • To configure jumper settings on XP-SNET-E32R output relays:

Step 1: The jumper settings location for the output relays are shown as below:
Jumper Settings Location for the XP-SNET-E32R Output Relays
Figure 1: Jumper settings location for the XP-SNET-E32R output relays


Note

Please note that for output relays 17 to 32, the jumpers are upside-down compared to the jumpers for output relays 1 to 16.



Step 2: Follow the table below to configure the jumper settings according to the specification for the output relays (dry contact vs wet contact & NO contact vs NC contact).


Note

  • The black bar indicates the pins required to be shorted.
  • The default jumper setting on XP-SNET-E32R extension board is Wet Contact with NO type.

Date Documentation:

23/5/2018 (Rev 1.0)

PROOF-READ

.

Related Articles.

Containing the label "e32r" AND "setup-guide"

.

.

© MicroEngine Technology Sdn Bhd (535550-U). All rights reserved.