How to Connect XP-M4L Controller to XP-SNET-E32R Extension Board for Lift Masking System Application

Owned by Tan Rong Wei (Unlicensed)
Last updated: Dec 30, 2020
1 min read

Problem (Issue) Statement:

How to connect XP-M4L controller to XP-SNET-E32R extension board for Lift Masking System Application

Description:

A guide to connect XP-M4L controller to XP-SNET-E32R extension board for Lift Masking System application.

Related Software:

  • xPortalNet v1.5.0.125

Related Hardware:

  • XP-M4L v4.01
  • XP-E32R v2.03

System Application:

  • Lift Masking Access System

Symptom and Finding:

NA

Cause:

For first time connection between XP-M4L controller with XP-SNET-E32R extension board for Lift Masking System application.

Solution:

Summary 

  • To connect XP-M4L controller to XP-SNET-E32R extension board. 

  • To configure DIP switches for address setting on XP-E32R extension board.

.

Step-by-step Guide:

  • To connect XP-M4L controller to XP-SNET-E32R extension board:

Step 1: Please follow the wiring diagram as shown below:

Wiring Diagram for Connection between XP-M4L Controller to XP-SNET-E32R Extension Board
Figure 1: Wiring diagram for connection between XP-M4L Controller to XP-SNET-E32R Extension Board


Step 2: The table below indicates the XP-SNET-E32R address settings and the corresponding relay number range.


Note

The XP-SNET-E32R extension board's relay address numbers are fixed and cannot be change.




  • To configure DIP switches for address setting on XP-E32R extension board.


Knowledge Base Link

Users can refer to How to Configure Address Unit No on XP-SNET-E32R Extension Board for the complete procedures on configuring the address settings on XP-SNET-E32R extension board.



Note

XP-M4L Lift Controller is supported in xPortalNet v1.5.0.117 and above.

Date Documentation:

17/7/2018 (Rev 1.0)

PROOF-READ

.

Related Articles.

Containing the label "lift-access-mode"  

.

.

© MicroEngine Technology Sdn Bhd (535550-U). All rights reserved.