Page Comparison

A guide to setup Lift Access System using XP-QNET controller.
 
Figure 1: Configuration Diagram for Lift Access System using XP-QNET Controller

.

For Lift access system application, the XP-QNET controller is used as Lift Controller and is connected to XP-SNET-E32R extension board for integration with Lift's Call Operation Panel to control the lift call buttons. The XP-MK820 reader interface module will be connected to Plato-Q81MS reader in support of multi-card types as access credential such as QR code, Mifare classic and Mifare Desfire cards.

.

Each XP-QNET controller is able to support up to a maximum of 10 number of Lift panels and a total relay output of 128.

Summary:

• Hardware 1: To configure XP-QNET Controller as Lift Controller

• Hardware 2: To assign IP Address for XP-QNET Controller

• Hardware 3: To connect Plato QR Reader or XP-MK820 Reader interface module

• Hardware 4: To connect XP-QNET controller to XP-SNET-E32R extension board

• Software 1: To configure lift access in xPortalNet HS PS v2.0 Server

• Software 2: To create floor zone and floor accessibility at xPortalNet HS PS v2.0 Client

Step-by-Step Guide:

• Anchor
  H1 H1

  Hardware 1: To configure XP-QNET Controller as Lift Controller:

Step 1: To configure XP-QNET controller to function as Lift Controller.

.

.

• Anchor
  H2 H2

  Hardware 2: To assign IP Address for XP-QNET Controller:

Step 1: To assign a static IP Address to XP-QNET controller via web diagnostic.

.

.

• Anchor
  H3 H3

  Hardware 3: To connect Plato QR Reader or XP-MK820 Reader interface module:

Step 1: XP-QNET controller has two ways to connect to the reader. For connection to Plato QR Reader, this can be directly connected to the controller. Alternatively, users should use the XP-MK820 Reader interface module to connect to third-party readers or facial recognition terminal devices.

.

.

.

.

Step 2: To assign Plato QR reader address or XP-MK820 Address Jumper Setting.

.

.

• Anchor
  H4 H4

  Hardware 4: To connect XP-QNET controller to XP-SNET-E32R extension board:

Step 1: To configure output relay jumper settings for XP-SNET-E32R.

.

.

Step 2: To configure address number on the XP-SNET-E32R extension board.

.

.

Step 3: To connect the XP-SNET-E32R extension to XP-QNET controller.

.

.

Step 4: To connect the Elevator COP buttons to XP-SNET-E32R extension board.

.

.

• Anchor
  S1 S1

  Software 1: To configure lift access in xPortalNet HS PS v2.0 Server:

Step 1: Launch xPortalNet HS PS v2.0 Server.

.

Step 2: To add new connection, controller, door, lift panel and floor relays.

.

.

• Anchor
  S2 S2

  Software 2: To create floor zone and floor accessibility at xPortalNet HS PS v2.0 Client:

Step 1: Launch xPortalNet HS PS v2.0 Client.

.

Step 2: To create new floor zone & floor accessibility.

.

.
Step 3: After completing this software configuration, go to xPortalNet Client > Device Comm > Send Door Setting to send the door settings to the controller.

.

Step 4: During testing, create a new card user and assign door accessibility & floor accessibility for complete testing of the configuration.