After Repairing the MCI, xPortalNet v1.0 Software is Still Unable to Detect the Plugged In License
Problem (Issue) Statement: | After repairing the MCI on-board license, xPortalNet v1.0 software is still unable to detect the connected license. |
Description: | Users discovered that even after repairing the MCI onboard license, the xPortalNet Services software is still unable to detect the connected license. |
Related Software: |
|
Related Hardware: |
|
System Application: | NIL |
Symptom and Finding: | When users attempt to launch xPortalNet Server v1.0.0.76, xPortalCommSvr will prompt an error message indicating “Get Key Error” as below:
Figure 1: Get Key Error Message |
Cause: | xPortalNet CommSvr is unable to detect MCI license due to XP-MCI-XNET baud rate being configured to 9600.
Figure 2: Jumper Setting to Configure Baud Rate of MCI Serial-to-USB Converter |
Solution: | Warning!
. . Summary
Step-by-step Guide:
Step 1: Switch off power supply for the MCI-XPNET and close the xPortalComm Svr software application. Step 2: Open MCI-XNET cover and take off the jumper to set the baud rate to 2400bps.
Figure 3: Removing the Jumper to Set the Baud Rate to 2400bps Step 3: Switch on the power supply for MCI-XPNET and plug into the PC’s serial comm port. Step 4: Run xPortalNet Server v1.0.0.76. The following message will be shown to indicate that the xPortal Comm Server is loaded. Click OK.
Figure 4: xPortal Comm Server Loaded Message Tip xPortal Software default baud rate is 2400. |
Date Documentation: | 19/7/2018 (Rev 1.0) |
PROOF-READ
.
.
.
© MicroEngine Technology Sdn Bhd (535550-U). All rights reserved.