How to Connect Third Party Readers to MK800E Reader Interface Module, and to Connect MK800E to XP-SNET Controller as well as to Configure Door Settings in xPortalNet Software

Problem (Issue) Statement:	How to connect third party readers to MK800E Reader Interface Module, and to connect MK800E to XP-SNET controller as well as to configure door settings in xPortalNet software
Description:	A guide to connect third party readers to MK800E Reader Interface Module, and to connect MK800E to XP-SNET controller as well as to configure door settings in xPortalNet software.
Related Software:	xPortalNet Lite xPortalNet Standard xPortalNet PS
Related Hardware:	XP-SNET XP-MK800E Third Party Reader
System Application:	Door Access System
Symptom and Finding:	NA
Cause:	For first time connection between third party readers to MK800E Reader Interface Module, and to connect MK800E to XP-SNET controller as well as to configure door settings in xPortalNet software.
Solution:	Warning! Users are not recommended to run any xPortal software in Windows XP* operating system as the system is unstable* Users are also advised to stop the xPortal Services before shutting down the Server PC* to prevent any missing transaction issues.* . . Summary To connect third party reader to MK800E Reader Interface Module. To connect MK800E to terminal block of CON33 on XP-SNET controller. To configure Door Setting on xPortalNet. Step-by-step Guide: To connect third party reader to MK800E Reader Interface Module: Step 1: Please follow the wiring diagram as below: Figure 1: Wiring diagram for third party readers to MK800E . . To connect MK800E to terminal block of CON33 on XP-SNET controller: Step 1: Please follow the wiring diagram as below: Figure 2: Wiring diagram for MK800E to XP-SNET controller . . To configure Door Setting on xPortalNet: Step 1: Ensure that the Connection and Controller setup has been completed. Knowledge Base Link Users may refer to How to Configure Connection, Controller, and Door Settings for XP-SNET controller with xPortalNet Software to complete the configuration settings. Step 2: For Door Setup, go to Server Admin > System Device Setup > Door > Add. The Door Setup window shown as below: Figure 3: Add Door window . Step 3: The table below shows the setting example for each door:
Date Documentation:	22/6/2018 (Rev 1.1)