...
Problem (Issue) Statement: | How to connect XP-GLS5000 controller with XP-SNET-E248 or XP-SNET-E32R Extension Board for Alarm Monitoring System Application | ||||||||||||||||||||||||||||||||
Description: | A guide to connect XP-GLS5000 controller to XP-SNET-E248 / XP-SNET-E32R extension board for Alarm Monitoring System application. | ||||||||||||||||||||||||||||||||
Related Software: |
| ||||||||||||||||||||||||||||||||
Related Hardware: |
| ||||||||||||||||||||||||||||||||
System Application: |
| ||||||||||||||||||||||||||||||||
Symptom and Finding: | NA | ||||||||||||||||||||||||||||||||
Cause: | For first time guide to connect XP-GLS5000 controller to XP-SNET-E248 / XP-SNET-E32R extension board for Alarm Monitoring System application. | ||||||||||||||||||||||||||||||||
Solution: | Summary:
|
| Anchor | ||||
|---|---|---|---|---|
|
Step 1: Please follow the wiring diagram as shown below: 
Figure 1: Wiring diagram between XP-SNET-E248 / XP-SNET-E32R extension boards to XP-GLS5000 controller
| Info | ||
|---|---|---|
| ||
|
.
.
Step 2: Users can now proceed to configure the address settings for the extension boards to facilitate communication in the network.
.
.
To configure DIP switches for address setting on XP-SNET-E248 / XP-SNET-E32R extension board:Anchor configure configure
Step 1: For XP-SNET-E248 extension board.
| Info | ||
|---|---|---|
| ||
Users may refer to How to Configure Address Unit no on XP-SNET-E248 Extension Board for the complete procedures to configure address settings for XP-SNET-E248. |
.
.
Step 2: For XP-SNET-E32R extension board.
| Info |
|---|
Users may refer to How to Configure Address Unit No on XP-SNET-E32R Extension Board for the complete procedures to configure address settings for XP-SNET-E32R. |
.
.
To observe the XP-SNET and XP-SNET-E248 / XP-SNET-E32R response after configuring the address of XP-SNET-E32R:Anchor observe observe
Step 1: Please ensure that door setting has sent to XP-GLS5000 controller.
| Info |
|---|
Users may refer to How to Send or Download Data to the Controller for the complete procedures to send door settings to the controller. |
.
.
Step 2: Next, on the XP-GLS5000 controller, ensure that both D33 & D34 LEDs in the "Downlink" section (lower left section of XP-GLS5000 controller) is blinking to indicate that the XP-GLS5000 controller has successfully established communication with the XP-SNET-E248 / XP-SNET-E32R extension board.
Step 3: On the XP-SNET-E248 / XP-SNET-E32R extension board, ensure that both Uplink LEDs are blinking. All output relay LEDs on the XP-SNET-E32R extension board will then be turned ON.
Date Documentation:
27/5/2018
...