How to Reset the Standalone Keypad Reader to Factory Default Setting (ColdStart)

Owned by Tan Rong Wei (Unlicensed)
Last updated: Dec 31, 2020
1 min read
Problem (Issue) Statement:How to reset the standalone keypad reader to factory default setting (ColdStart)
Description:Users failed to perform Coldstart.
Related Software:Nil
Related Hardware:
  • XP-SK32
  • XP-SR200K
  • XP-SR200KN
  • XP-SR1000
System Application:NIL
Symptom and Finding:

Users failed to coldstart the reader. The reader's memory does not clear even after the coldstart operation has been completed.

Cause:The reader may not be functioning properly
Solution:

Summary:

  • To perform ColdStart operation.

  • To send the controller in for repairs.

.

Step-by-step Guide:

  • To perform ColdStart operation:

Step 1: Switch off the power supply to the standalone reader.


Step 2: Upon switching on the standalone reader, it will enter into a power up mode, where the red LED will be blinking for 10 seconds.


Step 3: To perform the coldstart operation, press the exit button for 2 seconds.


Step 4: The standalone reader should be reset to factory default setting. If it does not, proceed to section 2 below.



  • To send the controller in for repairs:

Step 1: If users still failed to perform the coldstart operation, users are advised to send the standalone reader to MicroEngine Service Center for repairs.

Common Issues:NIL
Porting Date:22/2/2019

PROOF-READ

.

Related Articles.

Containing the label "standalone-reader"

.

.

© MicroEngine Technology Sdn Bhd (535550-U). All rights reserved.