Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Problem (Issue) Statement:

How to configure XP-SNET controller to integrate with turnstile system

Description:

A guide to configure XP-SNET controller to integrate with turnstile system.

Related Software:

  • xPortalNet Standard v1.5.0.154

Related Hardware:

  • XP-SNET v3.65
  • XP-MK800E v1.48
  • RDMFXE v3.01

System Application:

  • Turnstile Access System

Symptom and Finding:

NIL

Cause:

For first time configuration between XP-SNET controller and turnstile system for turnstile application integration.

Solution:

Summary:

Step-by-step Guide:

  • To perform ColdStart after first power up: 

Step 1: Press & hold the COLDSTART button on XP-SNET controller board.

Step 2: Press & release RESET button on XP-SNET controller board.

Step 3: Wait for both STAT and CPU LED to light up at the same time.

Step 4: Release COLDSTART button.

Note

Users are always recommended to perform ColdStart for new installations.




  • To perform pre-configuration setting on the network connection.


Knowledge Base Link

Users may refer to How to Pre-configure Network Connection for IP Controllers to complete the pre-configuration process.




  • To configure the IP address via Web Diagnostic.


Knowledge Base Link

Users may refer to How to Configure IP Address for IP Controllers to complete the configuration process.




  • To enable check exit reader door accessibility via Web Diagnostic:

Step 1: Open IE browser (Internet Explorer) and type the XP-SNET's IP address in the address box.


Note

The default IP address for XP-SNET controller is 192.168.1.210




Step 2: Enter the Username and Password and click OK to continue. The Web Diagnostic window will be shown as below. Click Configuration to continue.
Configuration Tab in Web Diagnostic Home Page
Figure 1: Configuration Tab in Web Diagnostic Home Page


Step 3: Scroll down to Door Controller Setup section. Tick the Check exit reader door accessibility checkbox and click Confirm Change Door Setting to continue. Check Exit Reader Door Accessibility Checkbox
Figure 2: Check Exit Reader Door Accessibility Checkbox


Step 4: Click Log Out to exit from the web diagnostic.
Exiting from Web Diagnostic by Logging Out
Figure 3: Exiting from Web Diagnostic by Logging Out


  • To Configure Connection, Controller, and Door Setting for XP-SNET controller with xPortalNet


Knowledge Base Link




  • To configure Door Access Level for Visitor user


Knowledge Base Link

User may refer to How to Configure Door Access Level at xPortalNet Software to complete the configuration process.

Date Documentation:

24/7/2018 (Rev 1.0)

PROOF-READ

  • No labels