...
Problem (Issue) Statement: | How to connect XP-GLS5000 controller to XP-SNET-E32R extension board for Lift Masking System application | ||||||||||||||||||||||||||||
Description: | A guide to connect XP-GLS5000 controller to XP-SNET-E32R extension board for Lift Masking System application | ||||||||||||||||||||||||||||
Related Software: |
| ||||||||||||||||||||||||||||
Related Hardware: |
| ||||||||||||||||||||||||||||
System Application: |
| ||||||||||||||||||||||||||||
Symptom and Finding: | NA | ||||||||||||||||||||||||||||
Cause: | For first time connection between XP-GLS 5000 controller with XP-SNET-E32R extension board for Lift Masking System application. | ||||||||||||||||||||||||||||
Solution: | Summary
|
| Anchor | ||||
|---|---|---|---|---|
|
Step 1: Ensure that the XP-GLS5000 controller is configured to Lift Controller Mode.
| Info | ||
|---|---|---|
| ||
Users may refer to How to Assign XP-GLS5000 Controller to Function as Lift Controller for the complete steps. |
To connect XP-SNET-E32R extension board to XP-GLS 5000 controller:Anchor 2 2
Step 1: Please follow the wiring diagram as shown below. 
Figure 1: Wiring Diagram between 4 XP-SNET-E32R Extension Boards to XP-GLS5000 Controller
Step 2: The table below indicates the XP-SNET-E32R address settings and the corresponding relay number ranges available for floor zone settings in the software. 
To configure DIP switches for address setting on XP-SNET-E32R extension board:Anchor 3 3
| Info | ||
|---|---|---|
| ||
Users can refer to How to Configure Address Unit No on XP-SNET-E32R Extension Board for the complete procedures on configuring the address settings on XP-SNET-E32R extension board. |
Date Documentation:
15/1/2019
...
| Section | |||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| |||||||||||||||||
|
.
...
.
| Choices for confluence | ||
|---|---|---|
|