How to Configure "Access Function Enabled or Input Output Processor Only" Mode using XP-SNET Controller

Access Function Enabled / Input Output Processor Only Mode:

• Prohibited from using door / floor access features
• Total Door Access level will increased up to 999 (in normal mode, total Door Access level is 255)

This article will guide users on how to configure "Access Function Enabled or Input Output Processor Only" mode using XP-SNET controller.

• xPortalNet

• XP-SNET
• XP-SNETv4

.

• To configure "Access Function Enabled or Input Output Processor Only" mode:

Step 1: Go to xPortalNet Server > Server Admin > System Device Setup > Controller > Add. The Add Controller window will be shown. At the Operation Mode field, select "Access Function Enabled / IO Processor Only". Click OK to save the changes.

Figure 1: Add Controller Window Selecting "Access Function Enabled / IO Processor Only" Mode

.

Step 2: The following message window will then be shown to highlight that this operation mode prohibits the use of door / floor access features. Click Yes to acknowledge the message and close the window.

Figure 2: The selected operation mode is prohibited to use any door / floor access features Message Window

.