How to Program Master Cards for XP-SR40 (Legacy Standalone Controller)
| Problem (Issue) Statement: | How to program Master Cards for XP-SR40 (legacy standalone controller) |
| Description: | XP-SR40 is a legacy standalone controller with a 40 card user capacity. The XP-SR40 requires the setting aside of 3 cards to be used as Master Cards, these Master Cards include:
This article will guide users on how to program Master Cards for XP-SR40 controller. |
| Related Software: | NIL |
| Related Hardware: |
|
| System Application: | NIL |
| Symptom and Finding: | NIL |
| Cause: | For first time guide on how to program Master Cards for XP-SR40 controller. |
Summary:
. Step-by-step Guide:
Note This section is only applicable for those applications where the programmed Master Cards are missing and users wished to re-program the Master Cards with new replacement cards. For first time installation of the three Master Cards, proceed to the next section. . . Step 1: After powering the XP-SR40 controller, press and hold the exit button for 2 seconds. Step 2: The XP-SR40 will beep every 1 second and the Green LED will be turned on. The EM lock will also be released. This is the Programming Mode of the controller. . .
Step 1: In the Programming Mode (after first power up or ColdStart operation), flash the card intended to be Master Card 1 for Install Card, then followed by the card intended to be Master Card 2 for Delete Card and Master Card 3 for Delete All Cards. Step 2: After the 3 Master Cards are programmed to the XP-SR40 controller, the controller will respond with the following responses:
| |
| Common Issues: | NIL |
| Porting Date: | 9/4/2019 |
PROOF-READ
.
.
.
© MicroEngine Technology Sdn Bhd (535550-U). All rights reserved.