How to Connect XP-M4L Controller to XP-SNET-E32R Extension Board for Lift Masking System Application

Problem (Issue) Statement:	How to connect XP-M4L controller to XP-SNET-E32R extension board for Lift Masking System Application
Description:	A guide to connect XP-M4L controller to XP-SNET-E32R extension board for Lift Masking System application.
Related Software:	xPortalNet v1.5.0.125
Related Hardware:	XP-M4L v4.01 XP-E32R v2.03
System Application:	Lift Masking Access System
Symptom and Finding:	NA
Cause:	For first time connection between XP-M4L controller with XP-SNET-E32R extension board for Lift Masking System application.
Solution:	Summary To connect XP-M4L controller to XP-SNET-E32R extension board. To configure DIP switches for address setting on XP-E32R extension board. . Step-by-step Guide: To connect XP-M4L controller to XP-SNET-E32R extension board: Step 1: Please follow the wiring diagram as shown below: Figure 1: Wiring diagram for connection between XP-M4L Controller to XP-SNET-E32R Extension Board Step 2: The table below indicates the XP-SNET-E32R address settings and the corresponding relay number range. Note The XP-SNET-E32R extension board's relay address numbers are fixed and cannot be change. To configure DIP switches for address setting on XP-E32R extension board. Knowledge Base Link Users can refer to How to Configure Address Unit No on XP-SNET-E32R Extension Board* for the complete procedures on configuring the address settings on XP-SNET-E32R extension board.* Note XP-M4L Lift Controller is supported in xPortalNet v1.5.0.117 and above.
Date Documentation:	17/7/2018 (Rev 1.0)

PROOF-READ

.

Summary

To connect XP-M4L controller to XP-SNET-E32R extension board.

To configure DIP switches for address setting on XP-E32R extension board.

Step-by-step Guide:

To connect XP-M4L controller to XP-SNET-E32R extension board:

Related Articles.

Filter by label