Summary:
.
Step-by-step Guide:
M1000i PoE Enclosure Contents:
Step 1: The contents within the PoE enclosure is shown as below:
Figure 1: Contents within the PoE Enclosure
Power Over Ethernet (PoE) Splitter Guide:
Step 1: Overview of the PoE splitter:
Figure 2: PoE Splitter Overview
Info |
---|
|
To change the output voltage, please plug out the PoE IN cable and wait for approximately 5 seconds until PWR LED is completely turned off before changing the output voltage. Figure 3: Disconnect PoE IN cable before changing the output voltage |
Step 2: Select the correct DC voltage output and connect the DC plug from DC OUT port to the incoming power terminal of XP-M1000i controller board.
Figure 4: (1) Select the correct output voltage; (2) connect the DC plug from DC OUT to incoming power terminal of XP-M1000i controller as shown in (3)
Step 3: Connect a standard UTP cable from ETHERNET port of the splitter to RJ45 port on XP-M1000i controller board.
Figure 5: Connecting UTP Cable from ETHERNET port to RJ45 Port on Controller
Step 4: Connect the standard UTP cable from PoE switch (on-site) to PoE IN port. Ensure that the PWR LED is turned ON.
Figure 6: Connecting UTP Cable from PoE Switch to PoE IN Port
Step 5: Power on the PoE switch to power on the PoE splitter and XP-M1000i controller.
Info |
---|
|
Users are advised to perform ColdStart operation once after every first time power up of the controller; or when advised to do so by the technical support. |