Page Comparison

Summary:

• Ensure that the xPortalNet HS Services is Running.

• Ensure that the alarm monitoring controller settings are configured in xPortalNet Server.

• To configure Instruction Control setup at xPortalNet client.

• To send Door Settings to Controller after completing the configuration.

• To observe the device status.

Step-by-step Guide:

• Anchor
  1 1

  Ensure that the xPortalNet HS Services is Running:

Step 1: Open xPortalNet Comm Service.

Step 2: Ensure that the xPortalNet Comm Service Status is Running.
Image Modified
Figure 1: xPortalNet Comm Service Running Pop-up Message

.

.

• Anchor
  2 2

  Ensure that the alarm monitoring controller settings are configured in xPortalNet Server:

.

.

• Anchor
  3 3

  To configure Instruction Control setup at xPortalNet HS client:

Step 1: Go to xPortalNet HS Client > System Setting > Instruction Control. The Instruction Setup window will be shown as below:
Image Modified
Figure 2: Instruction Setup Window

Step 2: Click Add to create a new instruction. The Add Instruction window will be shown as below. Fill in the respective fields and click OK to save changes.
Image Modified
Figure 3: Add Instruction Window

Image Modified

.

.

.

Step 3: Repeat steps 1 and 2 to add additional Instruction Setups as necessary.

Step 4: The following message window will be shown Record Added and click OKbutton.
Image Modified
Figure 4: Record Added Window
.

.

• Anchor
  4 4

  To send Door Setting to Controller after complete the configuration:

Step 1: After completing the configuration settings, users MUST send all settings to the controller.

Step 2: Go to Device Comm>Send Door Setting.
Image Modified
Figure 5: Send Door Setting Button

Step 3: Select the controller to send all settings. Click Send All Settings to send all configuration settings to the selected controller.

Step 4: The Delivery Report will be prompted. Ensure that software have sent all configuration settings successfully.
.

.

• Anchor
  5 5

  To observe the device status:

Step 1: To check the status of the controller, go to xPortalNet HSClient>Device List>Controller List to verify that the controller Status is Up.
Image Modified
Figure 6: Controller List under Device List tab

Step 2:To check the status of the controller, go to xPortalNet HSClient>Device List>Alarm Controller Listto verify that the alarm controller Status is Up.
Image Modified
Figure 7: Alarm Controller List under Device List tab

Step 3: To check the status of the controller, go to xPortalNet HS Client>Output List to verify that the output Status is OFF.
Image Modified
Figure 8: Output List under Device List tab

Image Modified