Summary:
Step-by-step Guide:
Ensure that the xPortalNet HS Services is Running:
Step 1: Open xPortalNet Comm Service.
Step 2: Ensure that the xPortalNet Comm Service Status is Running.
Figure 1: xPortalNet Comm Service Running Pop-up Message
.
.
Ensure that the alarm monitoring controller settings are configured in xPortalNet Server:
.
.
To configure Instruction Control setup at xPortalNet HS client:
Step 1: Go to xPortalNet HS Client > System Setting > Instruction Control. The Instruction Setup window will be shown as below:
Figure 2: Instruction Setup Window
Step 2: Click Add to create a new instruction. The Add Instruction window will be shown as below. Fill in the respective fields and click OK to save changes.
Figure 3: Add Instruction Window
.
- *represents required field
- Users can add up to a maximum of 8 Inputs and Outputs in one Instruction Setup.
|
.
.
Step 3: Repeat steps 1 and 2 to add additional Instruction Setups as necessary.
Step 4: The following message window will be shown Record Added and click OKbutton.
Figure 4: Record Added Window
.
.
To send Door Setting to Controller after complete the configuration:
Step 1: After completing the configuration settings, users MUST send all settings to the controller.
Step 2: Go to Device Comm>Send Door Setting.
Figure 5: Send Door Setting Button
Step 3: Select the controller to send all settings. Click Send All Settings to send all configuration settings to the selected controller.
Step 4: The Delivery Report will be prompted. Ensure that software have sent all configuration settings successfully.
.
.
To observe the device status:
Step 1: To check the status of the controller, go to xPortalNet HSClient>Device List>Controller List to verify that the controller Status is Up.
Figure 6: Controller List under Device List tab
Step 2:To check the status of the controller, go to xPortalNet HSClient>Device List>Alarm Controller Listto verify that the alarm controller Status is Up.
Figure 7: Alarm Controller List under Device List tab
Step 3: To check the status of the controller, go to xPortalNet HS Client>Output List to verify that the output Status is OFF.
Figure 8: Output List under Device List tab