How to configure the AntiPassBack function in controller Programming Menu for legacy XP-GT or XP-GTR controller
This article will guide users to configure the AntiPassBack function in controller Programming Menu for legacy XP-GT or XP-GTR controller.
- XP-GT1200L
- XP-GT3200L
- XP-GT1200LABX
- XP-GT3200LABX
- XP-GT3200LE
- XP-GT3200LCPX
- XP-GT5000LE
- XP-GTR1200L
- XP-GTR3200L
NIL
Summary:
To configure the AntiPassBack function in controller Programming Menu.
.
.
Step-by-step Guide:To configure the AntiPassBack function in controller Programming Menu:
Step 1: Enter the Programming Menu of the controller.
Users may refer to How to Enter into Programming Menu for Legacy XP-GT or XP-GTR Controllers for the complete steps on how to enter Programming Menu for the legacy XP-GT or XP-GTR controllers. |
.
.
Step 2: Press 1 for System Menu > 2 for Door Parameter. The screen below will be shown.
Figure 1: Door Parameter Screen
.
Step 3: Use the 
and 
to navigate the menu to the AntiPassBack screen. Press the 
key to enter into the parameter, and press the and key to change the value to ON and press key again to save the changes. Press the 
key to return to the System Menu.
.
Step 4: The Save Changes screen will then be shown. Press the key to confirm saving the changes.
Figure 2: Save Changes Screen
.
If the configuration is interrupted midway, the configuration changes will not be saved! |
.
.
Step 5: After saving the changes, at the screen of the idle mode, the AntiPassBack icon will be shown.
Figure 3: AntiPassBack Icon in the Idle Mode Screen
.
Users may refer to How to Clear AntiPassBack for the Legacy XP-GT or XP-GTR Series Controllers for the complete steps on how to reset the AntiPassBack flag for all the users in the controller. |
NIL
