How to Install the Redundancy Service

NIL

Step-by-step Guide: 

• To Install the Redundancy Service:

In these steps, user will be guided on how to install the Redundancy Service.

Step 1: Run the xPortalNet HS Redundancy Service.exe

Step 2: The following window will be shown.

^{Figure 1: Preparing to Install Window.}

Step 3: Wait for a while until the InstallShield Wizard window is shown. To continue, click Next.

^{Figure 2: InstallShield Wizard Window.}

Step 4: The License Agreement window will be shown. Please read the license agreement carefully and accept the terms to continue.

^{Figure 3: License Agreement Window.}

Step 5: The Customer Information window will be shown. Please enter the information and then click Next to continue.

^{Figure 4: Customer Information Window.}

Step 6: The Destination Folder window will be shown. Please specify the installation folder by clicking Change... button, then click Next to continue.

^{Figure 5: Destination Folder Window.}

Step 7: The Wizard is ready to begin the installation. Please make sure the installation settings are correct.

• Click Back if you want to review or change any settings.
• Click Install to start the installation.

^{Figure 7: Ready To Install Program Window.}

Step 8: Please wait until the installation completes.

^{Figure 8: Installing The Redundancy Service Window.}

Step 9: The installation has been completed. Click Finish to launch the program.

^{Figure 9: Installation Completed Window.}

Step 10: The status of the service can be seen from the System Tray. The status should be Running. 

^{Figure 10: Redundancy Status.}