Page Comparison

A guide to configure SGate Server to integrate with Mitsubishi ELSGW.

The SGate Server software is used to communicate between XP-SNET and Mitsubishi ELSGW. The ELSGW converts the elevator's call data into verified data and transmits to the elevator group control. The group control registers the elevator's call using the verified data and selects a car to assign to the call. Integration requires the SGate Server to manage communication between the Mitsubishi ELSGW and MicroEngine Access Control System in defining the destination floors that the passengers can access.

Figure 1: Illustration Diagram to Show the Interface between SGate Server and Mitsubishi ELSGW

Summary:

• To Configure LID Connection Setup.

• Continue with How To Use SGate Server for Mitsubishi ELSGW Lift Interfacing.

.

Step-by-step Guide:

• To Configure LID Connection Setup:

Step 1: Run SGate Server.

.

Step 2: In the left pane, click Connection. The following window will be shown.

Figure 2: Connection Setting window

.

.

Step 3: Click Save to confirm and save the changes.

.

Step 4: In the left pane, click Service. The following window will be shown. Turn on the service to start managing communication between elevator system and access control system.

Figure 3: Turn on SGate LID service window

.

Step 5: Verify that the SGate LID service is started successfully.

Figure 4: SGate LID Service Status Window

.

.

• To Use SGate Server for Mitsubishi ELSGW Lift Interfacing:

Step 1: Users can now begin to use SGate Server for Mitsubishi ELSGW Lift Interfacing.