Page Comparison

Summary:

• Ensure that xPortalNet HS Services is Running.

• To configure Connection Setup.

• To configure Controller Setup.

• To configure Alarm Controller Setup.

• To configure Output Setup.

• To configure Input Setup.

Step-by-Step Guide:

• Anchor
  running running

  Ensure that xPortalNet HS Services is Running:

Step 1: Open xPortalNet HS Comm Service.

Step 2: Ensure that the xPortalNet HS Comm Service Status is Running.

Figure 1: xPortalNet Comm Service Running Pop-up Message 

• Anchor
  connection connection

  To configure Connection Setup:

Step 1: Login to xPortalNet HS Server.

Step 2: Go to Server Admin > Connection Setup. The Connection Setup window will be shown as below.

Figure 2: Connection Setup window

Step 3: Click Add to add a new connection. The Add Connection window will be shown as below. Fill in the respective fields and click OK to save changes

Figure 3: Add Connection window

.

.

• Anchor
  controller controller

  To configure Controller Setup:

Step 1: Go to xPortalNet HS Server > Server Admin > System Device Setup > Controller. The Connection Setup window will be shown as below:

Figure 4: Controller Setup window

Step 2: Click Add to add a new controller device. The Add Connection Window will be shown as below. Fill up the respective field and click OK to save changes.

Figure 5: Add Controller window

Step 3: The following message window will be shown Record Added and click OKbutton.

Figure 6: Record Added window
.

. 

• Anchor
  alarm alarm

  To configure Alarm Controller Setup:

Step 1: Go to xPortalNet HS Server > Server Admin > System Device Setup > Alarm Controller. The Alarm Controller Setup window will be shown as below:

Figure 7: Alarm Controller Setup Window

Step 2: Click Add to add a new alarm controller device. The Add Alarm Controller window will be shown as below. Fill in the respective fields and click OK to save changes.
Figure 8: Add Alarm Controller Window

.

.
Step 3: The following message window will be shown Record Added and click OKbutton.

Figure 9: Record Added window
.

.

• Anchor
  output output

  To configure Output Setup:

Step 1: Go to xPortalNet HS Server > Server Admin > System Device Setup > Output Point. The Output Setup window will be shown as below:

Figure 10: Output Setup Window

Step 2: Click Add to add a new output device. The Add Output Window will be shown as below. Fill up the respective field and click OK to save changes.

Figure 11: Add Output Window

.

.
Step 3: The following message window will be prompted to show that Record is Added. Click OK to continue.

.

.

• Anchor
  input input

  To configure Input Setup:

Step 1:Go to xPortalNet HS Server > Server Admin > System Device Setup > Input Point. The Input Setup window will be shown as below:

Figure 13: Input Setup Window

Step 2: Click Add to add a new input device. The Add Input window will be shown as below. Fill up the respective field and click OK to save changes.

Figure 14: Add Input Window

.

.

Step 3: The following message window will be shown Record Added. Click OKto continue.

Figure 15: Record Added Window

Step 4: Users can then proceed to create an Instruction Control to configure the relationship between the Inputs and Outputs.