Skip to end of metadata
Go to start of metadata
You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 4
Next »
Problem (Issue) Statement: | How to configure address unit no on XP-SNET-E32R extension board |
Description: | A guide to configure address unit no on XP-SNET-E32R extension board. |
Related Software: | NA |
Related Hardware: | |
System Application: | - Lift Masking Access System
- Alarm Monitoring System
|
Symptom and Finding: | NA |
Cause: | For first time configuration for address unit no on XP-SNET-E32R extension board. |
Solution:
| Step 1: The XP-SNET-E32R address setting for the DIP switch can be referred to as shown below: Figure 1: The DIP switches for address setting location on the XP-SNET-E32R extension board Step 2: The table below shows the different DIP switch configurations for the respective address settings:
Step 3: The table below shows an example of the DIP switches settings for a XP-SNET-E32R extension board to be configured with address setting of unit no. "01":
Step 1: On the XP-SNET controller, ensure that both D33 & D34 LEDs in the "Downlink" section (lower left section of XP-SNET controller) is blinking to indicate that the XP-SNET controller has successfully established communication with the XP-SNET-E32R extension board.
Step 2: On the XP-SNET-E32R extension board, ensure that both Uplink LEDs are blinking. All output relay LEDs on the XP-SNET-E32R extension board will then be turned ON. |
Date Documentation: | 27/5/2018 (Rev 1.0) |
PROOF-READ
.
Related Articles.
Containing the label "e32r" AND "setup-guide"
Filter by label
There are no items with the selected labels at this time.