Page Comparison

This article will guide users on how to configure XP-M1000i or XP-M1300i controller using RS485 or RS232 connection.

• XP-M1000i
• XP-M1300i

• Anchor
  1 1

  To check Comm Port No connected to MCI or Serial-to-USB converter:

Step 1: Access the Windows Device Manager. Right-click at Computer > Manage.

Figure 1: Right-click Computer and Click Manage

.

If the MCI or Serial-to-USB converter is connected via RS232, the device will appear as a Communication Ports

Figure 2: Identifying Comm Port No for RS232 Connection

.

If the MCI or Serial-to-USB converter is connected via RS485, the device will appear as a USB to Serial Bridge

Figure 3: Identifying Comm Port No for RS485 Connection

.

.

• Anchor
  2 2

  To configure software settings:

.

.

Step 1: Go to xPortalNet Server > Server Admin > Connection Setup > Add. The Add Connection window will be shown. Fill in the information following the screenshot below, with the Comm No following the Comm Port No obtained in step 2 of the previous section.

Figure 4: Add Connection Window

.

Step 2: Go to xPortalNet Server > Server Admin > System Device Setup > Controller > Add. The Add Controller window will be shown. Fill in the information following the screenshot below, with the Unit No setup according to the controller address number.
 
Figure 5: Add Controller Window

.

Step 3: Go to xPortalNet Server > Server Admin > System Device Setup > Door > Add. The Add Door window will be shown. Fill in the information following the screenshot below, ensuring that the Unit No field is configured to "0".

Figure 6: Add Door Window

.

.

.

Step 4: At the software home window, go to Device List > Controller. Ensure that the status of the newly added controller is shown as "Up".

Figure 7: Controller List Window

.

Step 5: At the software home window, go to Device List > Door. Ensure that the status of the newly added door is shown as "Up".

Figure 8: Door List Window

.

Step 6: Go to xPortalNet Client > Device Comm > Send Door Setting > select the newly added controller > Send All Settings. The software will send the newly configured settings to the controller.