Step 1: Launch the xPortalNet HS Comm Service.
Step 2: Ensure that the xPortalNet HS Comm Service Status is Running.
Figure 1: xPortalNet HS Comm Service Controller Running Pop-up Message.
Step 3: Right-click the xPortalNet HS Comm Service Status icon at the notification bar, click Check Service Info and verify that the software has successfully detected the plugged in USB license key.
Figure 2: Valid Software License Key Detected
Step 1: Go to xPortalNet HS Server > Server Admin > Connection Setup. The Connection Setup window will be shown as below. Click Add to add a new connection.
Figure 3 Connection Setup Window
Step 2: The Add Connection window will be shown as below. Fill up the respective field and click OK to save the changes.
Figure 4: Add Connection Window
Step 3: The following message window will be prompted to indicated that the record is added. Click OK to continue.
Figure 5: Record Added Window
Step 4: Once configuration of connection is completed. Click Close to close the Connection Setup window.
Figure 6: Closing the Connection Setup Window
Step 5: The following message window will then be prompted to indicate that the request is submitted to refresh connection points. Click OK to continue.
Figure 7: Request Submitted to Refresh Connection Window
Step 1: Go to Server Admin > System Device Setup > Controller. The Controller Setup window will be shown as below. Click Add to add a new controller.
Figure 8: Controller Setup Window
Step 2: The Add Controller window will be shown as below. Fill up the respective field and click OK to save the changes.
Figure 9: Add Controller Window
Step 3: The following message window will be prompted to indicate that the record has been added. Click OK to continue.
Figure 10: Record Added Window
Step 4: Once configuration of controller is completed. Click Close to close the Controller Setup window.
Figure 11: Controller Setup Window
Step 5: The following message window will be prompted to indicate that the request is submitted to reload the controller list. Click OK to continue.
Figure 12: Request Submitted to Reload Controller List Window
Step 1: Go to Server Admin > System Device Setup > Door. The Door Setup window will be shown as below. Click Add to add a new controller.
Figure 13: Door Setup Window
Step 2: The Add Door window will be shown as below. Fill up the respective field and click OK to save the changes.
Figure 14: Add Door Window
Step 3: The following message window will be prompted to indicate that the record has been added. Click OK to continue.
Figure 15: Record Added Window
Step 4: Once configuration of door completed. Click Close to close the Door Setup window.
Figure 16: Door Setup Window
Step 5: The following message window will then be prompted to indicated that the request is submitted to reload door list. Click OK to continue.
Figure 17: Request Submitted to Reload Door List Window