Step 1: Press and hold the ColdStart button on the controller board.
Step 2: Turn off power supply.
Step 3: Turn on power supply.
Step 4: Release ColdStart button on the controller board after 3 seconds. The controller will respond with a long beep indicating that the ColdStart operation is in progress.
To install / add card user from XP-GT / XP-GTR controller for standalone controller application without connecting to any software:
Step 1: The following home screen will be shown after completing the ColdStart process.
Figure 1: LCD Home Screen
Step 2: Press asterisk key ({}) and enter the 6-digit default *MasterPIN.
Figure 2: Enter Default MasterPIN
| Info |
|---|
|
Default MasterPIN: 123456 |
Step 3: The following window will be shown to prompt users to change the MasterPIN. Enter the new MasterPIN which will be used to enter configuration menu from here onwards.
Figure 3: Enter a new MasterPIN
Step 4: The window will be prompt users to reconfirm the new MasterPIN. Re-enter the same MasterPIN to reconfirm.
Figure 4: Re-enter the new MasterPIN
Step 5: The following window will then be shown to indicate that the MasterPIN has been changed.
Figure 5: MasterPIN Updated Window
Step 6: The main menu layout will be shown as below. Press "2" to enter Database Menu.
Figure 6: Main Menu Layout
Step 7: The Database Menu will be shown. Press "2" to Add User.
Figure 7: Database Menu Layout
Step 8: The following window will be shown to prompt users to select the user type. Enter the key that corresponds to the correct user type. Press "√" to confirm.
Figure 8: Enter User Type Window
| Info |
|---|
|
The 4 available user types: - [0] for Prox Card
- [1] for ID No.
- [2] for Mifare (Contactless Smart Card)
- [3] for MyKad
|
Step 9: At the following window, enter the user's card number. Press "√" to confirm.
Figure 9: Enter User ID Number Window
| Info |
|---|
|
Default card number length for XP-GT3500L / ABL and XP-GTR1500L / ABL is 10-digits. |
Step 10: At the following window, enter the TimeZone number which will grant the respective card user access for this door. Press "√" to confirm.
Figure 10: Enter TimeZone No. Window
| Info |
|---|
|
There are 2 default timezone numbers: "00" for no access and "01" for free access. |
Step 11: The following window will then be shown. Specify whether to allow 1:N fingerprint operation. Press "√" to confirm.
Figure 11: Allow 1:N Operation Window
| Info |
|---|
|
This setting cannot be changed after saved. If system users select "No", the card user will only be able to use fingerprint if door's Verification Mode is selected to be fingerprint mode. |
Step 12: At the Verification Mode window, select the verification mode for the card user. Press "√" to confirm.
Figure 12: Verification Mode Window
Image Removed 
Image Added
Step 13: The Allow Config Access window will be shown. Users can choose whether the new user is allowed access into the Configuration Menu. Make the necessary selection and press "√" to confirm.
Figure 13: Allow Config Access Window
Step 14: The following window will be shown to indicate that the new user has been successfully added to the controller's memory.
Figure 14: New User Installed Window
Step 15: To continue adding another new user, press "√" and repeat steps 8 to 13. To exit to the Database Menu, press "X".
