Summary:
.
Step-by-step Guide:
| Anchor |
|---|
| wiring-diagram-96 |
|---|
| wiring-diagram-96 |
|---|
|
To follow wiring diagram as below:
Step 1: Wiring diagram XP-GT3200 controller – Fire Alarm signal connection.
Figure 1: Wiring Diagram for Fire Alarm Signal Connection to XP-GT3200 Controller
.
.
| Anchor |
|---|
| enable-fire-alarm-96 |
|---|
| enable-fire-alarm-96 |
|---|
|
To enable fire alarm release:
Step 1: After completing the fire alarm wiring termination, enter Configuration Menu to enable fire release setting at XP-GT3200 controller. Press *** and key in 6-digits MasterPIN.
Figure 2: Entering 6-digits MasterPIN
Step 2: Upon entering Configuration Menu, the Main Menu layout will be shown as below.
Figure 3: Main Menu Layout
Step 3: Press 1 for System Menu > 2 for Door Parameter > Press DOWN arrow key until the parameter of Fire Release is shown. Press √ to change the setting as shown below.
Figure 4: Fire Release Parameter
Step 4: To enable the Fire Release feature, press UP or DOWN arrow key to change the parameter setting to "Yes" and press √ again.
Figure 5: Changing the Setting for Fire Release Parameter
Step 5: Press X to exit from the Door Parameter menu. The following window will then be shown to confirm saving the changes. Press √ to confirm saving the changes.
Figure 6: Save Changes Window
Step 6: The following window will be shown to confirm that the Door Parameters are Updated. Please wait for the controller to revert back to home window (Idle Mode).
Figure 7: Door Parameters Updated Window
Step 7: The controller will automatically revert back to the home window (Idle Mode).
Figure 8: Home Window (Idle Mode)
.
.
To observe software response after triggering fire alarm signal:
Step 1: Users can test the programmed setup by triggering the fire alarm signal. The correct response observed from the hardware should be as follows:
- Electomagnetic lock will be released so that door can be accessed.
- Padlock icon on XP-GT controller's LCD screen will be shown as released to indicate that the Security status is OFF.
- MAS-RBT / MAS-RBU relay output LED will be turned ON to indicate that the electromagnetic lock is released.
Step 2: If the XP-GT controller is connected to the software, the Latest Event List tab will show Fire Alarm On and Door Security Off transactions.
Figure 9: Fire Alarm On and Door Security Off Transaction Logs
Step 3: When the fire alarm signal is cut off / back to normal, the Latest Event List tab will show Fire Alarm OFF transaction.
Figure 10: Fire Alarm Off Transaction Log
| Warning |
|---|
|
After fire alarm signal is cut off, XP-GT controller does not reset back to Security On condition. Users have to set / send Security On command to XP-GT controller. |
.
.
| Warning |
|---|
|
Users are not recommended to run any xPortal software in Windows XP operating system as the system is unstableUsers are also advised to stop the xPortal Services before shutting down the Server PC to prevent any missing transaction issues.
|
.
.
Step 1: To set Security On, enter Configuration Menu > System Menu > Door Parameter.
Step 2: Set Security OFF as "No" to enable the electromagnetic lock to secure the door.
Step 2: For software configuration to set Security On. Go to Device Comm > Send Door Command.
Figure 11: Downlaod Security On Transaction Log
