...
Problem (Issue) Statement: | After repairing the MCI on-board license, xPortalNet v1.0 software is still unable to detect the connected license. | ||||||||||
Description: | Users discovered that even after repairing the MCI onboard license, the xPortalNet Services software is still unable to detect the connected license. | ||||||||||
Related Software: |
| ||||||||||
Related Hardware: |
| ||||||||||
System Application: | NIL | ||||||||||
Symptom and Finding: | When users attempt to launch xPortalNet Server v1.0.0.76, xPortalCommSvr will prompt an error message indicating “Get Key Error” as below:
Figure 1: Get Key Error Message | ||||||||||
Cause: | xPortalNet CommSvr is unable to detect MCI license due to XP-MCI-XNET baud rate being configured to 9600.
Figure 2: Jumper Setting to Configure Baud Rate of MCI Serial-to-USB Converter | ||||||||||
Solution: |
. . Summary
Step-by-step Guide:
Step 1: Switch off power supply for the MCI-XPNET and close the xPortalComm Svr software application. Step 2: Open MCI-XNET cover and take off the jumper to set the baud rate to 2400bps.
Figure 3: Removing the Jumper to Set the Baud Rate to 2400bps Step 3: Switch on the power supply for MCI-XPNET and plug into the PC’s serial comm port. Step 4: Run xPortalNet Server v1.0.0.76. The following message will be shown to indicate that the xPortal Comm Server is loaded. Click OK.
Figure 4: xPortal Comm Server Loaded Message
| ||||||||||
Date Documentation: | 19/7/2018 (Rev 1.0) |
| Status | ||||||
|---|---|---|---|---|---|---|
|
.
.
| Section | |||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| |||||||||||||||||
|
.
...
.
| Choices for confluence | ||
|---|---|---|
|