Problem (Issue) Statement: | How to configure address unit no on XP-SNET-E32R extension board |
Description: | A guide to configure address unit no on XP-SNET-E32R extension board. | |||||
Related Software: | NA | |||||
Related Hardware: |
| |||||
System Application: |
| |||||
Symptom and Finding: | NA | |||||
Cause: | For first time configuration for address unit no on XP-SNET-E32R extension board. | |||||
Solution: | Summary
|
Info | ||
---|---|---|
| ||
The address of the extension boards must be unique (ranging from '00' to '03'), i.e.: no two extension boards in the same connection network can have the same address. |
To observe the XP-SNET and XP-SNET-E32R response after configuring the address of XP-SNET-E32R:
Step 1: On the XP-SNET controller, ensure that both D33 & D34 LEDs in the "Downlink" section (lower left section of XP-SNET controller) is blinking to indicate that the XP-SNET controller has successfully established communication with the XP-SNET-E32R extension board.
Step 2: On the XP-SNET-E32R extension board, ensure that both Uplink LEDs are blinking. All output relay LEDs on the XP-SNET-E32R extension board will then be turned ON.
Date Documentation:
27/5/2018 (Rev 1.0)