Page Comparison

Summary:

• To follow wiring diagram as below.

• To enable fire alarm release.

• To observe software response after triggering fire alarm signal.

• To configure Door status back to Normal Operation.

Step-by-step Guide:

• Anchor
  wiring-diagram-96 wiring-diagram-96

  To follow wiring diagram as below:

Step 1: Wiring diagram XP-GT3200 controller – Fire Alarm signal connection.
Image Modified
Figure 1: Wiring Diagram for Fire Alarm Signal Connection to XP-GT3200 Controller

• Anchor
  enable-fire-alarm-96 enable-fire-alarm-96

  To enable fire alarm release:

Step 1: After completing the fire alarm wiring termination, enter Configuration Menu to enable fire release setting at XP-GT3200 controller. Press *** and key in 6-digits MasterPIN.
Image Modified
Figure 2: Entering 6-digits MasterPIN

Step 2: Upon entering Configuration Menu, the Main Menu layout will be shown as below.
Image Modified
Figure 3: Main Menu Layout

Step 3: Press 1 for System Menu > 2 for Door Parameter > Press DOWN arrow key until the parameter of Fire Release is shown. Press √ to change the setting as shown below.
Image Modified
Figure 4: Fire Release Parameter

Step 4: To enable the Fire Release feature, press UP or DOWN arrow key to change the parameter setting to "Yes" and press √ again.
Image Modified
Figure 5: Changing the Setting for Fire Release Parameter

Step 5: Press X to exit from the Door Parameter menu. The following window will then be shown to confirm saving the changes. Press √ to confirm saving the changes.
Image Modified
Figure 6: Save Changes Window

Step 6: The following window will be shown to confirm that the Door Parameters are Updated. Please wait for the controller to revert back to home window (Idle Mode).
Image Modified
Figure 7: Door Parameters Updated Window

Step 7: The controller will automatically revert back to the home window (Idle Mode).
 Image Modified
Figure 8: Home Window (Idle Mode)

• Anchor
  observe-96 observe-96

  To observe software response after triggering fire alarm signal:

Step 1: Users can test the programmed setup by triggering the fire alarm signal. The correct response observed from the hardware should be as follows:

1. Electomagnetic lock will be released so that door can be accessed.
2. Padlock icon on XP-GT controller's LCD screen will be shown as released to indicate that the Security status is OFF.
3. MAS-RBT / MAS-RBU relay output LED will be turned ON to indicate that the electromagnetic lock is released.

Step 2: If the XP-GT controller is connected to the software, the Latest Event List tab will show Fire Alarm On and Door Security Off transactions.
Image Modified
Figure 9: Fire Alarm On and Door Security Off Transaction Logs

Step 3: When the fire alarm signal is cut off / back to normal, the Latest Event List tab will show Fire Alarm OFF transaction.
Image Modified
Figure 10: Fire Alarm Off Transaction Log

• Anchor
  normal-96 normal-96

  To configure Door status back to Normal Operation:

Step 1: To set Security On, enter Configuration Menu > System Menu > Door Parameter.

Step 2: Set Security OFF as "No" to enable the electromagnetic lock to secure the door.

Step 2: For software configuration to set Security On. Go to Device Comm > Send Door Command.
Image Modified

Figure 11: Downlaod Security On Transaction Log