Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Problem (Issue) Statement:

How to setup XP-M4L controller in xPortalNet software?

Description:

A guide to setup XP-M4L controller with xPortalNet software.

Related Software:

  • xPortalNet v1.5.0.125

Related Hardware:

  • XP-M4L v4.01
  • XP-E32R v2.03

System Application:

  • Lift Masking Access System

Symptom and Finding:

NA

Cause:

For first time configuration on XP-M4L controller with xPortalNet software.

Solution:

Summary.

  • To configure Connection setup.

  • To configure Controller setup.

  • To configure Lift Panel setup.

  • To configure Floor Relay setup.


Note

Before perform the following steps, please ensure the XP-M4L controller IP address was set.



Knowledge Base Link

User can refer How to Configure IP Address for IP Controllers to complete the configuration setting.


Step-by-step Guide:

  • To configure Connection setup:

Step 1: Go to xPortalNet Server > Server Admin > Connection Setup > Add.


Step 2: The Add Connection window will be shown. Fill in the Connection information accordingly. Click OK to save the changes.
Add Connection Window
Figure 1: Add Connection Window






  • To configure Controller setup:

Step 1: Go to xPortalNet Server > Server Admin > System Device Setup > Controller > Add.


Step 2: The Add Controller window will be shown. Fill in all controller information accordingly. Click OK to save the changes.
Add Controller Window
Figure 2: Add Controller Window






  • To configure Lift Panel setup:

Step 1: Go to xPortalNet Server > Server Admin > System Device Setup > Lift Panel > Add.


Step2: The Add Lift window will be shown. Fill in all lift information accordingly. Click OK to save the changes.
Add Lift Window
Figure 3: Add Lift Window





The table below indicates the Lift Panel number:



  • To configure Floor Relay setup:

Step 1: Go to xPortalNet Server > Server Admin > System Device Setup > Lift Panel > Add.


Step 2: The Add Floor Relay window will be shown. Fill in all floor relay information accordingly. Click OK to save the changes.
Add Floor Relay Window
Figure 4: Add Floor Relay Window





The table below shows the relay number scheme to be followed:



Step 3: Continue by creating Floor Zone and Floor Accessibility for the lift at xPortalNet Client.



Knowledge Base Link

Users may refer the How to Create Floor Zone and Floor Accessibility at xPortalNet Client for the complete process.

Date Documentation:

18/7/2018 (Rev 1.0)

PROOF-READ

  • No labels

© MicroEngine Technology Sdn Bhd (535550-U). All rights reserved.