Page Comparison

This article will guide users on how to configure XP-M1000x for Car Park Mode.

• XP-M1000x
• XP-M1000ABX
• XP-M1300X
• XP-M1300ABX
• XP-M1000XE
• XP-M1000CPX

• Anchor
  1 1

  Wiring diagram to connect XP-M1000x legacy controller to reader units and MAS-RBU relay boards:

Step 1: Please refer to the following wiring diagram for the connections between the XP-M1000x controller to the reader units:

Figure 1: Wiring Diagram for XP-M1000x Controller to Reader Units

.

.

Step 2: Alternatively, users can also connect the XP-M1000x controller to MAS-RBU relay boards by referring to the following wiring diagram.

Figure 2: Wiring Diagram for XP-M1000x Controller to MAS-RBU Relay Board

.

.

.

• Anchor
  2 2

  To configure Car Park Mode for the XP-M1000x legacy controller:

Step 1: Power up the controller.

.

Step 2: Enter the Programming Menu.

.

.

Step 3: Press 1 for Sys Menu > 6 for General Para. The General Parameter Setting screen will be shown. Press # to toggle between settings until the System Mode parameter is shown as below:

Figure 3: System Mode Parameter Screen

.

.

.

Step 4: Press 0 to cycle from one mode to another. The default operation mode is "DA". Keep pressing the # key until the save changes screen is shown, and press the # key again to save the changes.

Figure 4: Save Changes Screen