Page Comparison

.

.

.

.

Summary

• To configure XP-SNET-GAC controller device setup.

• To configure GAC setup.

• To enable GAC feature and assign Controllers as client GAC controllers to enforce Global AntiPassback.

.

Step-by-step Guide:

• Anchor
  1 1

  To configure XP-SNET-GAC controller device setup:

Step 1: Go to xPortalNet Server > Server Admin > System Device Setup > Connection > Add.

Step 2: The Add Connection window will be shown. Fill up the connection information accordingly. Click OK to save the changes.

Figure 1: Add Connection Window

Step 3: Go to xPortalNet Server > Server Admin > System Device Setup > Controller > Add.

Step 4: The Add Controller window will be shown. Fill in controller information accordingly. Click OK to save the changes.

Figure 2: Add Controller Window

• Anchor
  2 2

  To configure GAC setup:

Step 1: Go to xPortalNet Server > Server Admin > System Device Setup > GAC

Step 2: The GAC Setup window will be shown as below. Click Add to add a new GAC setup.

Figure 3: GAC Setup Window

Step 3: The Add GAC window will then be shown as below. Fill in GAC information accordingly and click OK to save the changes.

Figure 4: Add GAC Window

Step 4: The software will then prompt the following message window to indicate that the Record is added, Click OK to continue.

Figure 5: Record Added Window

• Anchor
  3 3

  To enable GAC feature and assign Controllers as client GAC controllers to enforce Global AntiPassback:

Step 1: Go to xPortalNet Server > Server Admin > System Device Setup > Controller.

Step 2: Select the controller to enable the enforcement of Global AntiPassback feature (as client GAC controllers) in Controller Setup window and click Modify to continue.

Step 3: The Edit Controller window will be shown. Under the Client Global AntiPassback Settings section, at the Use GAC field, click on the drop-down dialog box and select Yes. Fill in the remaining information for the section as shown below.

Figure 6: Client Global AntiPassback Settings Section in Edit Controller Window

Step 4: The software will then prompt the following message window to indicate that the Record is Updated. Click OK to continue.

Figure 7: Record Updated Window

Step 5: To assign another controller as GAC Client Controller, repeat step 2 and step 3.

3/7/2018 (Rev 1.0)