...
Problem (Issue) Statement: | How to configure input and output settings for XP-SNET-E248 extension board | ||||||||||||||||||||||||||||||||||
Description: | A guide to configure input and output settings for XP-SNET-E248 extension board. | ||||||||||||||||||||||||||||||||||
Related Software: | NA | ||||||||||||||||||||||||||||||||||
Related Hardware: |
| ||||||||||||||||||||||||||||||||||
System Application: |
| ||||||||||||||||||||||||||||||||||
Symptom and Finding: | NA | ||||||||||||||||||||||||||||||||||
Cause: | For first time configuration on input and output settings for E248 extension board. | ||||||||||||||||||||||||||||||||||
Solution: | Summary
. Step-by-step Guide:
Step 1: Please refer to the figure as shown below for an overview of the input and output points on the XP-SNET-E248 extension board:
Step 1: Follow the table below to configure the jumper settings according to the specification for the output relays (dry contact vs wet contact & NO contact vs NC contact).
Step 1: Please refer to the figure as shown below for Wet Contact relay output: Figure 2: Wet contact output connection Step 2: Please refer to the figure as below for Dry Contact relay output. Figure 3: Dry contact output connection
Step 1: Please refer to the figure as below for Normally Closed (NC) Sensor Input:
| ||||||||||||||||||||||||||||||||||
Date Documentation: | 19/6/2018 (Rev 1.1) |
...
Section | |||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| |||||||||||||||||
|
.
...
.
Choices for confluence | ||
---|---|---|
|