Step 1: Open xPortalNet Comm Service.
Step 2: Ensure that the xPortalNet Comm Service Status is Running.
Image Modified
Figure 2: xPortalNet Comm Service Running pop-up message
Step 1: Go to xPortalNet Client > System Setting > Instruction Control. The Instruction Setup window will be shown as below:
Image Modified
Figure 1: Instruction Setup Window
Step 2: Click Add to create a new instruction. The Add Instruction window will be shown as below. Fill in the respective fields and click OK to save changes.
Image Modified
Figure 2: Add Instruction Window
Image Modified
Info |
---|
|
- * represents required field
- Users can add up to a maximum of 8 Inputs and Outputs in one Instruction Setup.
|
Step 3: Repeat steps 1 and 2 to add additional Instruction Setups as necessary.
Step 4: The following message window will be prompted to show that Record is Added. Click OK to continue.
Image Modified
Figure 3: Record Added Window
Step 1: After completing the configuration settings, users MUST send all settings to the controller.
Step 2: Go to Device Comm > Send Door Setting.
Image Modified
Figure 4: Send Door Setting Button
Step 3: Select the controller to send all settings. Click Send All Settings to send all configuration settings to the selected controller.
Step 4: The Delivery Report will be prompted. Ensure that software have sent all configuration settings successfully.
Step 1: To check the status of the controller, go to xPortalNet Client > Device List > Controller List to verify that the controller Status is Up.
Image Modified
Figure 5: Controller List under Device List tab
Step 2:To check the status of the alarm controller, go to xPortalNet Client > Device List > Alarm Controller List to verify that the alarm controller Status is Up.
Image Modified
Figure 6: Alarm Controller List under Device List tab
Step 3: To check the status of the output, go to xPortalNet Client > Output List to observe the output status.
Image Modified
Figure 7: Output List under Device List tab
Image Modified
Step 4: To check the status of the input, go to xPortalNet Client > Input List to observe the input status.
Image Modified
Figure 8: Input List under Device List tab
Image Modified